TM 9-2320-260-34-2
APPENDIX E
ILLUSTRATED LIST OF MANUFACTURED ITEMS
This appendix includes complete instructions for making items authorized to be manufactured or fabricated
at direct and general support maintenance levels. A reference index is provided to indicate the illustration
associated with the manufacture of each item. All bulk materials needed for manufacture of an item are listed
by part number or specification number in a tabular list on the illustration.
FIG.
PAGE
TITLE
NO.
NO.
Dowel Pin
0.25-in. (6.35 mm) Radius Gage
Rear Output Shaft Adjusting Fixture
Intermediate Shaft Adjusting Fixture
Guide Screw
Dowel Pin
NOTE:
Two dowel pins are required.
PROCEDURE:
1. Fabricate from screw, part number MS90727-178 (NSN 5305-00-726-2572), or equivalent.
2. Remove head of screw at A.
3. Cut slot in screw at B. Slot will be large enough to accommodate screwdriver tip.
Figure E-1. Dowel Pin.
E-1