TM 9-2320-260-34-2
APPENDIX E (Contd)
NOTE:
The tolerance on all two place decimal dimensions is 0.03 in. (0.76 mm). The tolerance on all three
place decimal dimensions is 0.005 in. (0.127 mm).
PROCEDURE:
1. Trim sheet metal to dimensions shown in above diagram.
2. Drill one hole in sheet metal 0.5 in. (12.7 mm) in diameter.
3. Cut through center line of hole.
4. Remove burrs and sharp edges from sheet metal.
Figure E-2. 0.25-in. (6.35 mm) Radius Gage.
E-2