TM 9-2320-260-34-2
APPENDIX E (Contd)
MATERIALS
ITEM
NSN
DESCRIPTION
REQ'D
NO.
Bolt: MS16992-610
2
1
5306-00-412-9770
Bolt MS16992-609
1
3
Bolt Guide: 5-7/16 x 1-1/2 x 1-1/4, MS14296H389
1
4
Bolt Guide Support:
2
6
3/8 x 1-1/2 x 1-1/4, MS14296H403
3110-00-734-6759
Cover, Rear Bearing 7346759
1
1
Gage Support: 1-1/2 x 1-1/8 x 3/16, MS14296H369
5
NOTES
1. The tolerance on all two place decimal dimensions is 0.03 in. (0.76 mm). The tolerance on all
three place decimal dimensions is 0.005 in. (0.127 mm).
2. Refer tp TM 9-237, Operator's Manual: Welding Theory and Application, for welding
instructions.
PROCEDURE
1. Fabricate intermediate shaft adjusting fixture using materials and instructions above.
2. Assemble using instructions on next page.
Figure E-4. Intermediate Shaft Adjusting Fixture.
E-5
