TM 9-2320-260-34-2
16-49. DRIVE REPAIR (Contd)
1.
Position shaft (16) in housing (4).
Press bearings (2) and (14) onto shaft (16) and seat to shoulders (11) and (12) of shaft (16),
2.
Install two new woodruff keys (15) in shaft (16).
3.
4.
Position new gasket (3) and housing (1) over shaft (16), ensuring screw holes in housing (1) and
gasket (3) aline with screw holes in housing (4).
5.
Using a soft-head hammer, tap housing (1) over bearing (14).
Install four new Iockwashers (10) and screws (9) through housing (4) and into housing(1).
6.
NOTE
If retaining ring groove does not clear bearing, an additional
gasket must be installed between the two housings.
Install retaining ring (13) in groove on shoulder (12). If retaining ring (13) cannot be installed,
7.
go to step 8. If retaining ring (13) can be installed, go to step 13.
8.
Remove four screws (9) and Iockwashers (10) from housing (4).
Press on shaft (16) from inside housing (4) and separate housings (1) and (4).
9.
10.
Install a second new gasket (3) on housing (4). Repeat steps 5 and 6.
11.
Tap on outer race of bearing (14) until race is clear of retaining ring groove on shoulder (12).
12.
Install retaining ring (13) in groove on shoulder (12).
NOTE
Aline keyway in flange with key in shaft.
13.
Install flange (5) on shaft (16) with washer (6), new lockwasher (7), and screw (8).
FOLLOW-ON TASK: Install drive (para. 16-47).
16-298
