16-50. POWER DIVIDER GOVERNOR CONTROL VALVE REPLACEMENT (Contd)
b. Removal (34819)
1.
Remove air lines (5) and (16) and two sleeves (2) from elbow (1) and adapter (6). Discard sleeves (2).
2.
Remove cotter pin (15), washer (17), and control link (4) from air valve (3). Discard cotter pin (15).
3.
Remove two locknuts (7), screws (10), and air valve (3) from bracket (13). Discard locknuts (7).
4.
Remove elbow (1) and adapter (6) from air valve (3).
5.
Remove breather (9) and bushing (8) from air valve (3).
6.
Remove two locknuts (12), screws (14), and bracket (13) from crossmember (11). Discard
locknuts (12).
c. Installation (M819)
1. Install bracket (13) on crossmember (11) with two screws (14) and new locknuts (12).
2. Wrap male threads on elbow (1), air valve (3), bushing (8), and breather (9) with antiseize tape.
3. Install bushing (8) and breather (9) on air valve (3).
4. Install elbow (1) and adapter (6) on air valve (3).
5. Install air valve (3) on bracket (13) with two screws (10) and new locknuts (7).
6. Install two new sleeves (2) and air lines (5) and (16) on adapter (6) and elbow (1).
7. Install control link (4) on air valve (3) with washer (17) and new cotter pin (15).
d. Installation (M816)
1. Install bracket (35) on power divider (34) with two new lockwashers (32) and screws (31).
2. Wrap male threads on breather (20), bushing (21), elbow (24), and adapter (28) with antiseize tape.
3. Install bushing (21) and breather (20) on air valve (22).
4. Install elbow (24) and adapter (28) on air valve (22).
5. Install two spacers (19) and air valve (22) on bracket (35) with two screws (18) and new
locknuts (23).
6. Install two new sleeves (25) and air lines (26) and (27) on elbow (24) and adapter (28).
7. Install control link (33) on air valve (22) with two washers (29) and new cotter pin (30).
16-300
