TM 9-2320-260-34-2
16-48. POWER DIVIDER REPAIR (Contd)
43. Position winch shaft (2) in housing (3) and install winch gear (9) and bearing (4) on winch shaft (2).
NOTE
Bearing should be even with inside of housing.
44. Install bearing (1) on winch shaft (2).
45. Install new gasket (5) and cover (6) with four new lockwashers (7) and screws (8).
46. Install new seal (18) in cover (15).
47. Install new gasket (19) and cover (15) on splined end of winch shaft (2) and housing (3) with four new
Iockwashers (16) and screws (17).
48. Check end play of winch shaft (2):
a. Attach dial indicator to winch shaft (2) and housing (3).
b. Move winch shaft (2) back and forth and record end play movement.
c. If end play of winch shaft. (2) is between 0.010-0.033 in. (0.25-0.84 mm), remove dial indicator
and go to Step 51.
d. If end play of winch shaft (2) is not between 0.010-0.033 in. (0.25-0.84 mm), then perform
steps 49 and 50 until end play of winch shaft (2) is correct.
49. Remove four screws (17), lockwashers (16), and cover (15) from housing (3). Discard lockwashers (16).
50. Install or remove a new gasket (19), then replace cover (15) on housing (3) with four new lock-
washers (16) and screws (17). Go back to step 48b.
51. Install yoke (14) on winch shaft (2) with new gasket (13), washer (12), new lockwasher (11), and
screw (10).
16-294
