TM 9-232&260-34-2
16-48. POWER DIVIDER REPAIR (Contd)
Install new gasket (12) and cover (13) on housing (6) with four new lockwashers (14) and
19.
screws (15).
20.
Install new seal (17) in cover (18).
21.
Install new gasket (16) and cover (18) on housing (6) with four new lockwashers (20) and
screws (19).
22,
Check end play of input shaft:
a. Attach dial indicator to end of input shaft (3).
b. Move input shaft (3) back and forth and record end play movement.
c. If end play of input shaft (3) is between 0.010-0.033 in. (0.25-0.84 mm), remove dial indicator
and go to Step 25.
d. If end play of input shaft (3) is not between 0.010-0.033 in. (0.25-0.84 mm), then perform
steps 23 and 24 until end play of input shaft (3) is correct.
23.
Remove four screws (19), Iockwashers (20), and cover (18) from housing (6). Discard
lockwashers (20).
24.
Install or remove a new gasket (16), then replace cover (18) on housing (6) with four new lock-
washers (20) and screws (19). Go back to step 22b.
25.
Install yoke (25) on input shaft (3) and housing (6) with new gasket (24), washer (23), new
lockwasher (22), and screw (21).
16-291