TM 9-2320-260-34-2
16-41. TRANSMISSION POWER TAKEOFF REPAIR (Contd)
Remove cotter pin (1) from PTO housing (2) and input gear pin (3), Discard cotter pin (l).
8.
Using drift punch, remove input gear pin (3) from PTO housing (2). Remove end with cotter pin
9.
hole first.
Remove two thrust washers (4) and input gear (6) from PTO housing (2).
10.
11.
Remove two bearings (5) from input gear (6).
NOTE
Perform steps 12 through 24 for dual output shaft PTO.
12.
Remove plug (17), spring (18), and ball (19) from cover (12).
13,
Remove five screws (11), lockwashers (10), cover ( 12), and gasket (9) from PTO housing (2). Discard
lockwashers (10) and gasket (9).
Remove snapring (8) from reverse gear shaft (7).
14.
Loosen jamnut (15) and remove eye bolt (14) and washer (13) from rear output shift pin (16).
15.
16.
Remove safety wire (25) from screw (24) and shifter fork (20). Discard safety wire (25).
17.
Remove screw (24) from shifter fork (20) and rear output shift pin (16).
18.
Using brass drift, remove rear output shift pin (16) from shifter fork (20) and cover (12).
19.
Remove retainer (22) and boot (23) from cover (12). Discard retainer (22),
Remove seal (21) from cover (12). Discard seal (21).
20.
Remove seal (31) from cover (12). Discard seal (31).
21.
Remove snapring (30) from rear output shaft (27).
22.
Using arbor press, remove rear output shaft (27) and clutch gear (26) from bearing (29) and
23.
cover (12). Separate clutch gear (26) and rear output shaft (27).
Remove two snaprings (28) and bearing (29) from cover ( 12).
24.
DUAL OUTPUT
16-234
