TM 9-2320-260-34-2
16-41. TRANSMISSION POWER TAKEOFF REPAIR (Contd)
NOTE
Perform step 25 for single output shaft PTO.
25.
Remove five screws (4), lockwashers (3), cover (5), and gasket (2) from PTO housing (1). Discard
lockwashers (3) and gasket (2).
--
26.
Remove four screws (6), lock washers (7), cover (11), and gasket (9) from PTO housing (1) and front
output shaft (8). Discard lockwashers (7) and gasket (9).
Remove seal (10) from cover (11). Discard seal (10).
27.
Using arbor press, remove front output shaft (8) from bearing (17). As front output shaft (8) comes
28.
out of bearing ( 17) and is clear, gear (18) can be removed from front output shaft (8) and PTO
housing (1).
Using arbor press, remove bearing (17) and spacer (16) from PTO housing (1).
29.
Using mechnical puller and arbor press, remove bearing ( 12) from front output shaft (8).
30.
Remove snapring (13) from front output shaft (8).
31.
32.
Remove thrust washer (14) and gear (15) from front output shaft (8).
33.
Remove cotter pin (28) and clevis pin (25) from reverse gear (27) and reverse gear shaft (23). Discard
cotter pin (28).
Using arbor press, remove bearing (22) and reverse gear shaft (23) from PTO housing (1) and
34.
reverse gear (27). Press on splined end of reverse gear shaft (23).
Remove reverse gear (27) and two thrust washers (26) from PTO housing (1).
35.
36.
Using bearing puller, remove bearing (19) from PTO housing ( 1).
37.
Remove woodruff key (21) from reverse gear shaft (23). Discard woodruff key (21).
38.
Remove plug (20) and two screws (24) from PTO housing (1).
16-236
