TM 9-2320-260-34-2
16-41. TRANSMISSION POWER TAKEOFF REPAIR
THIS TASK COVERS:
a. Disassembly
Assembly
c.
b. Cleaning, Inspection, and Repair
lNITIAL SETUP
MATERIALS/PARTS (Contd)
APPLICABLE MODELS
All
Gasket (Appendix D, Item 134)
TOOLS
Gasket (Appendix D, Item 110)
General mechanic's tool kit
Gasket (Appendix D, Item 108)
(Appendix B, Item 1)
Woodruff key (Appendix D, Item 564)
Mechanical puller kit (Appendix B, Item 14)
Bushing (Appendix D, Item 11)
Outside micrometer (Appendix B, Item 8)
Safety wire (Appendix D, Item 375)
Inside micrometer (Appendix B, Item 9)
GAA grease (Appendix C, Item 14)
Vernier caliper (Appendix B, Item 33)
Lubricating oil (Appendix C, Item 20)
Arbor press (Appendix B, Item 7)
Sealing compound (Appendix C, Item 42)
Mineral oil (Appendix C, Item 23)
MATERIALS/PARTS
REFERENCES (TM)
Fifteen lockwashers (Appendix D, Item 252)
Two retainers (dual output)
TM 9-2320-260-34P-2
EQUIPMENT CONDITION
Cotter pin (Appendix D, Item 50)
Transmission power takeoff removed (para. 16-40).
Cotter pin (Appendix D, Item 19)
Three seals (Appendix D, Item 465)
Three retainers (Appendix D, Item 338)
I
a. Disassembly
1. Remove six screws (7), lockwashers (6), cover (5), and gasket (4) from PTO housing (8). Discard
lockwashers (6) and gasket (4).
2. Remove retainer (1), spring (2), and ball (3) from PTO housing (8).
3. Remove safety wire (11) and screw (10) from shift fork ( 12). Discard safety wire (11).
4. Remove screw (15) and washer (14) from shift pin (13) and slide shift pin (13) out of two boots (9),
shift fork (12), and PTO housing (8).
5. Remove shift fork (12) from PTO housing (8).
6. Remove two boots (9) and retainers (17) from PTO housing (8). Discard retainers (17).
7. Remove two seals (16) from PTO housing (8). Discard seals ( 16).
16-232
