TM 9-2320-260-34-2
16-41. TRANSMISSION POWER TAKEOFF REPAIR (Contd)
I
b. Cleaning, Inspection, and Repair
1.
For general cleaning instructions, refer to para. 2-8.
2.
For general inspection instructions, refer to para. 2-9.
Inspect reverse gear shaft (l), front output shaft (3), rear output shaft (4), main shift fork (6), rear
3.
shift fork (7), input gear pin (8), shift pin (9), and rear output Shift pin (10) for scores breaks, cracks,
pits, burrs, nicks, and wear. Refer to table 16-16, Transmission PTO Wear Limits, for measure-
ments. Repair minor burrs or scoring. Replace part(s) if damaged or worn past limits.
4.
Inspect front output shaft cover (5) for scores, breaks, cracks, pits, burrs, and nicks. Replace front
output shaft cover (5) if damaged.
NOTE
Perform step 5 for dual output shaft PTO.
Inspect rear output shaft (4), rear shift fork (7), and rear output shift pin (10) for scores, breaks,
5.
cracks, pits, burrs, nicks, and wear. Refer to table 16-16, Transmission PTO Wear Limits, for
measurements. Replace rear output shaft (4), rear shift fork (7), or rear output shift pin (10) if
damaged or worn past limits.
6.
Inspect bushing (2) of reverse gear shaft (1) for scores, overheating, and wear. Refer to table 16-16,
Transmission PTO Wear Limits, for measurements. Replace bushing (2) if damaged or worn.
NOTE
Perform steps 7 and 8 if reverse gear shaft bushing requires
replacement.
7.
Using puller, remove bushing (2) from reverse gear shaft (1). Discard bushing (2).
8.
Using arbor press, install new bushing (2) in reverse gear shaft (1).
16-238
