TM 9-2320-260-34-1
THIS TASK COVERS:
c. Repair
a. Disassembly
d. Assembly
b. Cleaning and Inspection
lNITIAL SETUP
MATERIALS/PARTS (Contd)
APPLICABLE MODELS
Two gaskets (Appendix D, Item 140)
All
Gasket (Appendix D, Item 141)
SPECIAL TOOLS
Gasket (Appendix D, Item 142)
Universal puller kit (Appendix B, Item 75)
Gasket (Appendix D, Item 143)
Gasket (Appendix D, Item 144)
TOOLS
Gasket (Appendix D, Item 145)
General mechanic's tool kit (Appendix B, Item 1)
Six locknuts (Appendix D, Item 180)
Transmission maintenance stand
Locknut (Appendix D, Item 174)
(Appendix B, Item 110)
Three seals (Appendix D, Item 430)
Dial indicator (Appendix B, Item 11)
Two seals (Appendix D, Item 432)
Seal (Appendix D, Item 471)
(Appendix B, Item 3)
Seal (Appendix D, Item 472)
Lockwasher (Appendix D, Item 239)
(Appendix B, Item 2)
Four lockwashers (Appendix D, Item 223)
Bearing remover/replacer
Four lockwashers (Appendix D, Item 215)
(Appendix B, Item 83)
Oil seal replacer (Appendix B, Item 157)
Four tab lockwashers (Appendix D, Item 523)
Companion flange replacer
White carbonate pigment (Appendix C, Item 27)
(Appendix B, Item 96)
Sealing compound (Appendix C, Item 43)
Bearing cone adapter (Appendix B, Item 97)
Sealing compound (Appendix C, Item 44)
Chains
Lubricating oil (Appendix C, Item 22)
2-1/8-in. socket, 1-in. dr.
Crocus cloth (Appendix C, Item 53)
(Appendix B, Item 20)
Safety wire (Appendix C, Item 59)
Adapter, 3/4 to 1-in. dr. (Appendix B, Item 19)
PERSONNEL REQUIRED
Lifting device
Arbor press (Appendix B, Item 7)
Two
REFERENCES (TM)
Soft-head hammer (Appendix B, Item 47)
TM 9-214 -
Feeler gage (Appendix B, Item 58)
Adjusting fixture (Appendix E, Figure E-3)
TM 9-2320-260-20
Adjusting fixture (Appendix E, Figure E-5)
TM 9-2320-260-34P-1
MATERIALS/PARTS
EQUIPMENT CONDITION
TwO locktab washers (Appendix D, Item 208)
Four woodruff keys (Appendix D, Item 547)
Parking brakeshoes removed (TM 9-2320-260-20).
TwO sleeves (PTO models) (Appendix D, Item 510)
GENERAL SAFETY INSTRUCTIONS
Three cotter pins (Appendix D, Item 25)
Shim (Appendix D, Item 505)
All personnel must stand clear during lifting
Shim (Appendix D, Item 506)
operations.
1. Attach lifting device to lifting bracket (2) on transfer (1).
NOTE
Steps 2 and 3 are an alternate method of connecting lifting device to
transfer.
3. Attach ends of chain to transfer(1) with two longer screws (6), four washers (7), and nuts (3) and
attach chain to lifting device.