TM 9-2320-260-34-1
I
9-3. TRANSFER REPLACEMENT (Contd)
WARNING
Use prybar to free transfer from hang-ups or snags. Failure to
do so may result in injury to personnel.
Ensure transfer is securely mounted to jack with safety chain or
strap. Failure to do so may result in injury to personnel.
Transfer is heavy and bulky. Allow adequate clearance to remove
transfer from vehicle. Failure to do so may result in injury or
death to personnel.
NOTE
Assistant will help with steps 8 through 12.
8. Position transmission jack with transfer lift under transfer (6) and raise until transfer (6) weight is
on transmission jack. Secure transfer (6) to transmission jack with safety chain or strap.
9. Remove three screws (4), lockwashers (5), four screws (8), and lockwashers (7) from two brackets (2)
and transfer (6). Discard lockwashers (5) and (7).
10. Lower transmission jack and turn right side of transfer (6) toward rear of vehicle.
11.
Remove transmission jack and transfer (6) from under vehicle.
12. Remove three locknuts (12), screws (10), washers (9), six insulators (11), and two brackets (2) from
frame rails (1) and (3). Discard locknuts (12) and insulators (11).
b. Installation
1.
Install two brackets (2) and six new insulators (11) on frame rails (1) and (3) and brackets (13) with
three screws (10), washers (9), and new locknuts (12). Tighten locknuts (12) until distance from top
of washer (9) to bracket (13) is 1.94 in. (49.3 mm) as shown.
WARNING
Ensure transfer is securely mounted to jack with safety chain or
q
strap. Failure to do so may result in injury to personnel.
Transfer is heavy and bulky. Allow adequate clearance to remove
q
transfer from vehicle. Failure to do so may result in injury or
death to personnel.
NOTE
Assistant will help with steps 2 through 6.
2.
Mount transfer (6) on transmission jack with transfer lift. Secure transfer (6) to transmission jack
with safety chain or strap.
With right side of transfer (6) toward rear of vehicle, move transmission jack and transfer (6) under
3.
vehicle from left side.
4.
When transmission jack and transfer (6) are in position, turn transmission jack and transfer (6) 90
to the left.
Raise transfer (6) to aline mounting pads to brackets (2).
5.
Install transfer (6) on two mounting brackets (2) with three new lockwashers (5), screws (4), four
6.
new lockwashers (7), and screws (8). Tighten screws (4) and (8) 125-135 lb-ft (170-183 Nm).
9-8
