TM 9-2320-260-34-1
3-19. CAM FOLLOWER HOUSING MAINTENANCE (Contd)
e. Assembly
NOTE
Lightly oil all parts before assembly.
Use new push tubes if new sockets were installed.
1.
Install roller (4) in cam follower lever ( 1).
2.
Holding 0.006 in. (0.152 mm) feeler gage between cam follower lever (1) and roller (4), aline hole
in roller pin (2) with hole in cam follower lever (1) and press roller pin (2) through cam follower
lever (1) and roller (4).
Insert retaining pin (3) into cam follower lever (1) and roller pin (2).
3.
NOTE
Ensure cam follower levers are positioned in cam follower housing
in previously marked locations.
Position six cam follower levers (1) in cam follower housing (6).
4.
Aline holes in two follower shafts (5) with holes in cam follower housing (6) and insert follower
5.
shafts (5) through cam follower housing (6) and cam follower levers (1).
Insert two setscrews (7) into cam follower housing (6) and follower shafts (5).
6.
CAUTION
Press two plugs into housing until flush with cam follower housing
to avoid screw breakage.
Install two new plugs (8) into cam follower housing (6).
7.
3-56