TM 9-2320-260-20
4-52. WIRING HARNESS REPAIR (Contd)
c. Receptacle Cable Connector (With Sleeve) Repair
1. Slide shell (3) and sleeve (4) over cable (1).
2. Strip insulation from cable (1) equal to depth of terminal well (5).
3. Insert conductor (2) into terminal well (5) and crimp terminal well (5) tightly.
4. Slide sleeve (4) and shell (3) over terminal (6).
I
I
d. Plug Assembly Repair
NOTE
Refer to TM 9-237 for soldering instructions.
1.
Slide retaining nut (8) over cable (7).
2.
Strip covering from cable (7), exposing leads (9).
Insert leads (9) through holes in grommet (14).
3.
Trim leads (9) to even length from face of grommet (14).
4.
5.
Strip insulation from each lead (9) equal to depth of solder wells (11) on inserts (12).
6.
Solder conductors (10) in solder wells (11) of inserts (12).
7.
Seat leads (9) and inserts (12) in grommet (14) and install grommet (14) in shell assembly (13).
Thread retaining nut (8) on shell assembly (13) until seated.
8.
4-108
