TM 9-2320-260-20
I
THIS TASK COVERS:
a. Blackout Drive Lamp Removal
c. Blackout Drive Light Housing Installation
b. Blackout Drive Light Housing Removal
d. Blackout Drive Lamp Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Two lockwashers
Four locknuts
Parking brake set (TM 9-2320-260-10).
Three O-rings
Battery ground cable disconnected (para. 4-48).
Gasket
I
a. Blackout Drive Lamp Removal
1. Remove three screws (14), lens cover (15), three O-rings (13), and gasket (12) from housing (1).
Discard O-rings (13) and gasket (12).
2. Remove lamp (16) from housing (1).
b. Blackout Drive Light Housing Removal
NOTE
Tag all wires for installation.
1. Disconnect wire (3) from connector plug (2).
2. Remove nut (10), lockwasher (9), mounting washer (8), housing (1), and lockwasher (11) from
bracket (6). Discard lockwashers (9) and (11).
3. Remove four locknuts (7), screws (4), and mounting bracket (6) from headlight bracket (5). Discard
locknuts (7).
I
C.
Blackout Drive Light Housing Installation
1. Install mounting bracket (6) on headlight bracket (5) with four screws (4) and new locknuts (7).
2. Install housing (1) to mounting bracket (6) with new lockwasher (11), mounting washer (8), new
lockwasher (9), and nut (10).
3. Connect wire (3) to connector plug (2).
d. Blackout Drive Lamp Installation
1. Install lamp (16) in housing (1).
2. Install new gasket (12), three new O-rings (13), and lens cover (15) on housing (1) with three
screws (14).
4-74
