FRONT COMPOSITE LAMPS, HOUSING, AND BRACKET REPLACEMENT

TM 9-2320-260-20

4-40. FRONT COMPOSITE LAMPS, HOUSING, AND BRACKET REPLACEMENT

THIS TASK COVERS:

a. Composite Lamps Removal

c. Composite Light Housing Installation

b. Composite Light Housing Removal

d. Composite Lamps Installation

INITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

All

TM 9-2320-260-10

TM 9-2320-260-20P

MATERIALS/PARTS

EQUIPMENT CONDITION

Two lockwashers

Four locknuts

Parking brake set (TM 9-2320-260-10).

Battery ground cable disconnected (para. 4-48).

a. Composite Lamps Removal

Loosen five screws (1) and remove lens cover (15) and gasket (14) from composite light housing (3).

2. Remove lamp(s) (2) from composite light housing (3).

b. Composite Light Housing Removal

1. Remove four screws (13), locknuts (10), and cover (9) from fender (11) and bracket (12). Discard

locknuts (10).

2. Remove two screws (7) and lockwashers (6) from composite light housing (3) and bracket (12).

Remove bracket (12). Discard lockwashers (6).

NOTE

Tag all wires for installation.

3. Disconnect three wires (4) from wiring harness connectors (5) and remove composite light

housing (3).

4. Remove two grommets (8) from bracket (12) and cover (9).

c. Composite Light Housing Installation

1. Connect three wires (4) to wiring harness connectors (5).

2. Place two grommets (8) around three wires (5) and install on fender (11) and bracket (12).

3. Install composite light housing (3) on bracket (12) with two new lockwashers (6) and screws (7).

4. Install bracket (12) and cover (9) on fender (11) with four screws (13) and new locknuts (10).

d. Composite Lamps Installation

1. Install lamp(s) (2) in composite light housing (3).

2. Install gasket (14) and lens cover (15) and tighten five screws (1).

4-72