TM 9-2320-260-20
4-43. FLOODLIGHT HOUSING AND MOUNT REPLACEMENT (Contd)
3. Remove three screws (1), retaining ring (2), and three O-rings (3) from housing (11).
4. Remove four springs (28) and lamp (4) from retaining ring (2).
5. Remove two screws (5) and (7) and lamp wires (6) from lamp (4).
6. Disconnect switch wire (22) and lamp wire (6) from housing (11).
7. Remove two connectors (21) and grommets (20) from housing (11).
8. Remove two screws (27), retainer (26), and pressure switch (25) from switch housing (24).
9. Remove two screws (16), lockwashers (15), spacers (23), and switch housing (24) from housing (11).
Discard lockwashers (15).
10. Remove two nuts (8), lockwashers (9), washers (10), screws (17), six washers (14), four spring
washers (18), and housing (11) from mounting bracket (19). Discard lockwashers (9).
11. Remove two spacers (13) and grommets (12) from housing (11).
b. Installation
1.
Install two grommets (12) and spacers (13) on housing (11).
2.
Install housing (11) on mounting bracket (19) with four spring washers (18), six washers (14), two
screws (17), washers (10), new lockwashers (9), and nuts (8).
3.
Install switch housing (24) in housing (11) with two new lockwashers (15) and screws (16).
4.
Install pressure switch (25) and retainer (26) on switch housing (24) with two screws (27).
5.
Install two grommets (20) and connectors (21) on housing (11).
6.
Connect switch wire (22) and lamp wire (6) to two connectors (21) in housing (11).
7.
Install four springs (28) and lamp (4) on retaining ring (2).
8.
Install two lamp wires (6) on lamp (4) with two screws (5) and (7).
9.
Install lamp (4) and retaining ring (2) on housing (11) with three O-rings (3) and screws (1).
4-78
