TM 9-2320-260-20
I
THIS TASK COVERS:
c. Signal Light Housing Installation
a. Signal Lamp Removal
b. Signal Light Housing Removal
d. Signal Lamp Installation
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-260-10).
M816, M819
Battery ground cable disconnected (para. 4-48).
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Four locknuts
Lockwasher
Eye protection must, be worn when removing or
installing springs under tension.
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
I
a. Signal Lamp Removal
1. Remove three screws (17) and retaining ring (1) from lamp housing (6).
2. Disconnect wires (4) and (5) from lamp housing (6).
Eye protection must be worn when removing or installing springs
under tension. Failure to do so may result in injury to personnel.
3.
Remove three springs (3) and lamp (2) from retaining ring (1).
b. Signal Light Housing Removal
1. Disconnect wire (7) from lamp housing (6).
2. Remove nut (14), lockwasher (15), mounting washer (16), and lamp housing (6) from bracket (12).
Discard lockwasher (15).
3. Remove four locknuts (9), screws (13), bracket (12), and protector box (10) from fender (11). Discard
locknuts (9).
4. Remove grommet (8) and wire (7) from fender (11).
c. Signal Light Housing Installation
1. Insert wire (7) through hole in fender (11).
2. Place grommet (8) around wire (7) and install on fender (11).
3. Position bracket (12) and protector box (10) on fender (11) and install with four screws (13) and
new locknuts (9).
4. Install lamp housing (6) on bracket (12) with mounting washer (16), new lockwasher (15), and
nut (14).
5. Connect wire (7) to lamp housing (6).
4-70
