C3, TM 9-2320-211-20
Figure 2-272. Rear end of
M62 with floor plate raised--left side
view.
(3) Disconnect front propeller shaft rear universal
a. Removal.
(1) Remove rear winch as described in paragraph
(4) Remove universal joint at each end of front
2-320b.
(2) Remove four capscrews and lockwashers
(3) Remove four capscrews, four lockwashers, and
two hexagon nuts securing cable tensioner to end frame
b. Installation.
(1) Position cable tensioner on rear of winch, and
aline holes in right tension sheave frame bracket and end
two nuts in holes in bracket and end frame.
.
holes in left tension sheave frame bracket (7) and gearcase
(removed from M62).
b. Installation.
a. Removal.
(1) Install universal joint at each end of front
(1) Disconnect front propeller shaft and front
universal joint from yoke on power divider winch output
(2) Attach rear propeller shaft slip yoke to front
(2) Pull propeller shaft toward front of
vehicle, and
(3) Slide rear propeller shaft slip yoke, with front
remove rear universal joint with slip yoke assembly, from
propeller shaft attached, on front (splined) end of rear