2-29. E l e c t r i c a l P o w e r L o s s T e s t s -- D i e s e l a n d
TM 9-2320-211-20
Multifuel
Refer to paragraph 2-28 for applicable tests..
2-30. M o n i t o r i n g
Circuits (Fuel, Oil, and
Temperature Gage Testing)
a. Check the vehicle battery voltage. Charge or
replace the battery if the voltage is not as prescribed
b. Check the battery cables and terminals for
g o o d condition. Repair or replace battery cables
and terminals as required. Be sure that they are
properly secured.
c. With the ignition switch turned to OFF,
disconnect the No. 27 lead from the back of the
g a g e (fig. 2-33).
Figure 2-32. Starter
solenoid-to-starter
connector
test.
e. With the ignition switch turned to ON (fig. 2-
d. With the voltage selector on the 50-volt scale,
34), the voltmeter should indicate battery voltage.
connect the negative (--) lead of the voltmeter to
vehicle ground and the positive (+) lead to wire
No. 27 from the ignition switch.
