TM 9-2320-392-10-1
30K WINCH OPERATION - Continued
0035 00
30K WINCH OPERATION WITHOUT LOAD - Continued
CAUTION
Ensure there are no gaps between layers of cable. Gaps between cable
layers indicate loose winding. Failure to comply may result in damage to
equipment.
NOTE
Perform steps 22 through 25 if cable is not winding properly.
22. Position MAIN WINCH RH switch (9) to OUT.
23. Pay out cable (10) until cable on 30K winch drum has clean wind.
CAUTION
Do not dead-end cable into rear rollers. Failure to comply may result in
damage to equipment.
24. Position MAIN WINCH RH SPEED switch (8) to LOW.
25. Continue steps 20 through 25 until cable (10) is fully recovered.
0035 00-22
