TM 9-2320-366-20-5
Section II. MAINTENANCE PROCEDURES
This task covers:
a. Disassembly
c. Follow-On Maintenance
b. Assembly
INITIAL SETUP
Tools and Special Tools
Materials/Parts (Cont)
Tool Kit, Genl Mech (Item 46, Appendix C)
Nut, Self-Locking (2) (Item 128, Appendix G)
Vise, Machinist (Item 48, Appendix C)
Nut, Self-Locking (6) (Item 167, Appendix G)
Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C)
Grommet, Nonmetallic (Item 47, Appendix G)
Socket Set, Socket Wrench (Item 36, Appendix C)
Lockwasher (4) (Item 77, Appendix G)
Washer, Nylon (3) (Item 185, Appendix G)
Washer, Nylon (3) (Item 284, Appendix G)
Materials/Parts
Adhesive (Item 5, Appendix D)
Insert, Nylon (3) (Item 57, Appendix G)
Nut, Plain, Hex (Item 127, Appendix G)
Insert, Nylon (2) (Item 59, Appendix G)
a. Disassembly.
(1) Remove amber warning light cable (1) from support
bracket (2).
NOTE
Note location of clamp prior to removal.
(2) Remove self-locking nut (3), washer (4), nylon insert (5),
clamp (6), nylon washer (7), and washer (8) from screw
(9). Discard self-locking nut, nylon insert, and nylon
washer.
(3) Remove two self-locking nuts (10), washers (11), nylon
inserts (12), nylon washers (13), and washers (14) from
screws (15). Discard self-locking nuts, nylon inserts, and
nylon washers.
(4) Remove support ring (16) from support bracket (2).
