TM 9-2320-366-20-5
(4) Position two washers (8) and screws (9) in inner
side support (10) with two self locking nuts (11).
(5) Tighten two self-locking nuts (11) to 110-120 lb-in.
(12-14 Nm).
WARNING
Adhesives,
solvents,
and
sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water. Failure
to comply may result in injury to
personnel.
(6) Apply sealant to threads of four screws (12).
(7)
Install EPLRS shelf (13) and inter side support (10)
on support legs (4) with four washers (14) and
screws (12).
(8)
Position outside support (15) on inter side support
(10) with three washers (16), screws (17), and self-
locking nuts (18).
(9) Position mid rear support (19) on EPLRS shelf (13)
with three washers (20), screws (21), and self
locking nuts (22).
(10) Position four washers (23) and screws (24) in
support legs (4) with self-locking nuts (25).
(11) Tighten three self-locking nuts (22) and four self-
locking nuts (25) to 110-120 lb-in. (12-13 Nm).
Change 2
20-535