TM 9-2320-366-20-4
This task covers:
a.
Platform Removal
e. Bracket Removal
b.
Platform Installation
f. Bracket Installation
c.
Platform Disassembly
g. Follow-On Maintenance
d.
Platform Assembly
INITIAL SETUP
Equipment Conditions
Material/Parts
Upper platform removed (para 14-7).
Nut, Self-Locking (8) (Item 156, Appendix G)
Nut, Self-Locking (4) (Item 169, Appendix G)
Nut, Self-Locking (7) (Item 154, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Nut, Self-Locking (6) (Item 158, Appendix G)
Sling, Cargo (Item 31, Appendix C)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Personnel Required
Goggles, Industrial (Item 15, Appendix C)
(3)
Wrench, Torque, 0-600 lb-ft (Item 60, Appendix C)
Wrench Set, Socket (Item 50, Appendix C)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Platform Removal.
NOTE
Left and right side fenders are removed the
same way. Right side shown.
(1) Remove two self-locking nuts (1) and screws (2)
from bracket (3). Discard self-locking nuts.
(2) Remove two self-locking nuts (4), insulation
washers (5), washers (6), screws (7), and fender (3)
from platform (8). Discard self-locking nuts.
Change 2
