TM 9-2320-366-20-4
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools
Engine shut down (TM 9-2320-366-10-1).
a. Removal.
(1) Disconnect connector P110 (1) from CTIS ECU (2).
(2) Remove screw (3), washer (4), and terminal lug TL50 (5)
from CTIS ECU (2).
(3) Remove two screws (6), washers (7), and CTIS ECU (2)
from personnel heater (8).
b. Installation.
(1) Install CTIS ECU (2) on personnel heater (8) with
terminal lug TL50 (5), washer (4), and screw (3).
(2) Install two washers (7) and screws (6) in CTIS ECU (2).
(3) Connect connector P110 (1) to CTIS ECU (2).
c. Follow-On Maintenance.
(1) Start engine (TM 9-2320-366-10-1).
(2) Operate CTIS and check for proper operation (TM 9-
2320-366-10-1).
(3) Shut down engine (TM 9-2320-366-10-1).
End of Task.