TM 9-2320-366-20-4
(2) Inspect differential pinion gears (3) for cracked or broken
gear teeth, scoring, pitting, and corrosion. Replace
differential pinion gear(s) that fail inspection.
(3) Inspect pinion gear bearings (4) for scoring, pitting, and
corrosion. Replace radial pinion gear bearing(s) that fail
inspection.
(4) Inspect differential spider (5) for cracks, scoring, pitting,
and corrosion. Replace differential spider that fail
inspection.
c. Installation.
NOTE
Front, intermediate, and rear axle different-ial
spider assemblies are installed the same
way. Left front axle differential spider
assembly shown.
(1) Install four pinion gear bearings (1), differential pinion
and outer thrust washers (5) on differential spider (6).
(2) Install four preformed packings (7) on differential spider
(6).
NOTE
If pins in self-locking nut do not line up with
holes in inner bevel side gear, adjust self-
locking nut accordingly.
(3) Install inner bevel side gear (8) in wheel end hub
assembly (9) with holes in inner bevel side gear aligned
with pins in self-locking nut (10).
10-15
