TM 9-2320-366-20-4
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Material/Parts
Dump body raised to maintenance position (TM 9-
Dispenser, Pressure Sensitive Adhesive Tape
2320-366-10-1).
(Item 20, Appendix D)
Batteries disconnected (para 7-57).
Cap and Plug Set (Item 14, Appendix D)
Ties, Cable, Plastic (Item 69, Appendix D)
Nut, Self-Locking (6) (Item 155, Appendix G)
Tools and Special Tools
Goggles, Industrial (Item 15, Appendix C)
Nut, Self-Locking (12) (Item 154, Appendix G)
Pan, Drain (Item 24, Appendix C)
Packing, Preformed (2) (Item 178.1, Appendix G)
Tool Kit, Genl Mech (Item 46, Appendix C)
Packing, Preformed (4) (Item 179, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Transmission Auxiliary Oil Cooler Rubber Seal
Wrench, Torque 0-200 lb-in.(Item 60, Appendix C)
(2) (Item E-10, Appendix E)
Socket Set, Socket Wrench (Item 34, Appendix C)
Crowfoot Attachment, Socket Set (Item 12.1,
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the possibility
of falling debris. Failure to comply may
result in injury to personnel.
Ensure exhaust system is cool before
preforming maintenance. Failure to comply
may result in severe burns.
a. Removal.
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector clamp (1) from connector P209
(2).
(2) Disconnect connector P209 (2) from connector J209 (3).
Change 1
