TM 9-2320-272-24-4
NOTE
Chain is necessary to prevent main and output flanges from
rotating when removing hardware.
Tag main and front output flanges for installation.
Install chain on main flange (5) and output flange (11) with two washers (9), screw (10), two
16.
washers (3), screw (2), and nut (4).
Remove locknut (8) and washer (7) from main input shaft (6). Discard locknut (8).
17.
Remove locknut (1) and washer (13) from front output shaft (12). Discard locknut (1).
18.
Remove screw (10), two washers (9), nut (4), washer (3), screw (2), washer (3), and chain from main
19.
flange (5) and output flange (11).
Using puller, remove main flange (5) and output flange (11) from main input shaft (6) and front
20.
output shaft (12).
NOTE
Perform steps 21 and 22 for vehicles equipped with PTO.
Remove six screws (15), washers (16), and PTO (14) from transfer case (17).
21.
Remove setscrew (19), PTO drive gear (18). and seal (20) from main input shaft (6). Discard
22.
seal (20).
5-402
