TM 9-2320-272-24-2
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
REFERENCES (TM)
APPLICABLE MODELS
LO 9-2320-272-12
M925/A1/A2, M928/A1/A2, M929/A1/A2,
TM 9-2320-272-10
M930/A1/A2, M932/A1/A2, M936/A1/A2
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
Hydraulic oil reservoir drained (LO 9-2320-272-12).
Eight locknuts (Appendix D. Item 291)
GENERAL SAFETY INSTRUCTIONS
Tiedown straps (Appendix D, Item 695)
Cap and plug set (Appendix C, Item 14)
Store or dispose of used oil properly.
Antiseize tape (Appendix C, Item 72)
Accidental or intentional introduction of liquid contaminants into
the environment is in violation of state, federal, and military
regulations. Refer to Army POL (para. 1-8) for information
concerning storage, use, and disposal of these liquids. Failure to do
so may result in injury or death.
When disconnecting hydraulic lines and hoses, plug all openings to
prevent dirt from entering and causing damage to internal parts.
NOTE
Have drainage container ready to catch oil.
Tag all hydraulic lines for installation.
1.
Remove tiedown straps from oil supply hose (6) as required. Discard tiedown straps.
While holding nut (5), loosen nut (4) and remove oil supply hose (6) from elbow (1).
2.
Loosen nut (10) and remove oil return hose (9) from elbow (11).
3.
Remove elbow (1) and nipple (2) from reservoir (3).
4.
Remove nut (18), screw (8), clamp (7), and oil return hose (9) from reservoir (3).
5.
Remove eight locknuts (17) and screws (16) from frame bracket (19) and reservoir (3). Discard
6.
locknuts (17).
Remove and pull reservoir (3) out about 2 in. (5 cm) from frame bracket (19).
7.
8.
Remove reservoir (3) from frame bracket (19).
9.
Remove elbow (11) from reservoir (19).
10.
Remove filler cap (15), dipstick (14), spacer (13), and strainer (12) from reservoir (3).
3-860
