TM 9-2320-272-24-2
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M925/A1/A2, M928/A1/A2, M929/A1/A2,
LO 9-2320-272-12
M930/Al/A2, M932/A1/A2, M936/A1/A2
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Torque wrench (Appendix E, Item 146)
Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
Oil filter and gasket (Appendix D, Item 492)
NOTE
The oil filter is located on the right frame rail above the wet
tank air reservoir.
Have drainage container ready to catch oil.
1.
Loosen center bolt (6) and remove filter housing (7), spring (3), and gasket (2) from filter base (1).
Discard gasket (2).
2.
Remove center bolt (6), washer (5), and oil filter (4) from filter housing (7). Discard oil filter (4).
1.
Install washer (5), center bolt (6), new oil filter (4), and spring (3) in filter housing (7).
2.
Position new gasket (2) on filter base (1).
3.
Install filter housing (7) on gasket (2) and filter base (1) with center bolt (6). Tighten center bolt (6)
30-35 lb-ft (41-47 Nm).
3-858