TM 9-2320-272-24-1
Table 2-3. Electrical Troubleshooting (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test 7. Test positive cable 6 from batteries to starter solenoid.
Step 1. Set multimeter to lo-volt range.
Step 2. Connect multimeter positive lead to positive terminal point on batteries and negative
lead to positive terminal on starter solenoid.
Step 3. Crank engine and observe multimeter. A voltage reading exceeding 0.4 volt indicates
loose or corroded connection.
Clean and tighten connections at batteries, starter, and chassis (para. 3-124).
2-107
