TM 9-2320-272-24-1
Table 2-3. Electrical Troubleshooting (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test 4. Test starter-to-solenoid strap.
Step 1. Set multimeter to 10-volt range.
Step 2. Connect multimeter negative lead to positive terminal stud of starter and positive lead
to terminal stud of solenoid.
Step 3. Crank engine and observe multimeter. A voltage reading exceeding 0.1 volt indicates bad
connection at starter terminal stud and terminal stud of solenoid.
Clean and tighten connections.
2-104
