TM 9-2320-260-34-2
16-48. POWER DIVIDER REPAIR (Contd)
Coat seals with gear oil before installation.
q
q Coat all internal parts of power divider with light coat of gear oil
before assembly.
1.
Aline lever (9) on shifter shaft (7) and install with new lockwasher (10) and screw (11).
2.
Install two new seals (6) in bores (5).
3.
Slide shifter shaft (7) with lever (9) into bore (5) of shifter housing (17).
Install shift fork (3) with pin (4) alined to pin hole (8) on shifter shaft (7) with new lockwasher (2)
4.
and screw (1).
NOTE
Ensure ball bearing is seated in groove.
Aline grooves (12) in shifter shaft (7) with bore (16) in single shifter housing (17) and install ball
5.
bearing (13) and spring (14) in single shifter housing (17) with retainer (15).
Install adapter (20), nipple (19) and breather (18) in double shifter housing (21).
6.
Install plug (25) in double shifter housing (21).
7.
Install two new seals (24) and new expansion plugs (23) in bores (22) of double shifter housing (21).
8.
NOTE
Aline marks on levers with marks on shifter shafts.
9.
Install levers (28) and (30) on shifter shafts (34) and (41) in double shifter housing bores (22) with
new lockwashers (27) and (31) and screws (26) and (32).
NOTE
Both forks are mounted on shifter shafts the same, but positioned
opposite. Pin holes aline with forks on shifter shafts.
10.
Aline two ins (45) with holes (29) and (33) in shifter shafts (41) and (34) and install two forks (42)
with new lockwashers (44) and screws (43).
11.
Aline grooves (40) and (35) in shifter shafts (34) and (41) with bores (39) in double shifter
housing (21), and install two ball bearings (36) and springs (37) in double shifter housing (21)
with two retainers (38).
12.
Aline marks on bracket (46) and housing (47) and place bracket (46) over studs (48).
13.
Install bracket (46) on housing (47) with four slotted nuts (49) and new cotter pins (50).
16-288
