TM 9-2320-260-34-2
16-9. REAR WINCH LEVEL WIND MAINTENANCE (Contd)
6. Inspect four thrust washers (1), two axles (2), forty-five ball bearings (8), and four trolley wheels (13)
for breaks, cracks, scoring, corrosion, chips, damaged threads, flat spots, and excessive wear. Refer
to table 16-9, Rear Winch Level Wind Wear Limits, for measurements. Replace part(s) if damaged
or worn.
7. Inspect pivot shaft (3), trolley frame (6), track frame (7), latch (9), and two races (12) for breaks,
cracks, scoring, corrosion, chips, and flat spots. Refer to table 16-9, Rear Winch Level Wind Limits,
for measurements. Replace part(s) if damaged.
NOTE
Perform steps 8 and 9 if trolley axle fails inspection.
q
Both axles are removed and installed the same. This procedure
q
covers one axle.
8. Using arbor press, remove axle (2) from trolley frame (6). Discard axle (2).
9. Using arbor press, install new axle (2) on trolley frame (6).
16-64
