TM 9-2320-260-34-1
9-4. TRANSFER REPAIR (Contd)
NOTE
Perform steps 101 and 102 if plates are not on shaft.
101.
Aline holes in plate (17) and new locktab washer (16) with intermediate shaft (2) and install with
two screws (15). Tighten screws (15) 45-57 lb-ft (61-77 Nm).
102.
Bend four tabs of locktab washer (16) over flats of two screws (15).
NOTE
Use shim pack thickness from step 89 or 90.
103.
Coat front and back of shim pack (8) with thin coat of sealing compound and position shim pack (8)
and cover (9) over intermediate shaft (2). Hold in place with two screws (11) installed finger tight
in upper two screw holes on housing (1).
104.
Install cover (9) and bracket (14) on housing (1) with two new lockwashers (13) and screws (12)
in lower two holes. Tighten screws (12) finger tight.
105,
Remove two upper screws (11) in cover (9) and position bracket (7) over cover (9). Install cover (9)
and bracket (7) on housing (1) with two new lockwashers (10) and screws (11).
106.
Alternately tighten four screws (11) and (12) 60-80 lb-ft (8 1-109 Nm).
NOTE
Use shim pack thickness from step 91 or 92.
107.
Coat front and back of shim pack (25) with thin coat of sealing compound.
Position shim pack (25) and cap (24) over rear output shaft (26) and on housing (1) and install with
108.
six new lockwashers (23) and screws (22). Tighten screws (22) 40-55 lb-ft (54-75 Nm).
Install shield (27) and flange (28) on brakedrum (21) with six new locknuts (29).
109.
110.
Install brakedrum (21) on rear output shaft (26) with washer (20) and nut (19). Tighten nut (19)
300-400 lb-ft (407-542 Nm) and install new cotter pin (18).
111.
Coat gasket (3) with thin coat of sealing compound and aline on housing (1).
112.
Install cover (4) over gasket (3) on housing (1) with six new lockwashers (5) and screws (6).
Tighten screws (6) 40-55 lb-ft (54-75 Nm).
9-54