TM 9-2320-260-34-1
9-4. TRANSFER REPAIR (Contd)
Set rear output shaft (6) end free play using feeler gage.
92.
Install cap (2) over rear output shaft (6) and on housing (1) with six washers (3) and screws (4).
a.
Tighten screws (4) evenly finger tight.
Seat rear bearing (8) and race (9) by tapping on seal and cap (1) with soft-head hammer.
b.
Tighten screws (4) alternately 12-15 lb-ft (16-20 Nm). Then repeat tightening sequence for
c.
torque of 15-20 lb-ft (20-27 Nm).
d.
Measure gap (7) between housing (1) and cap (2) at three points around circumference of contact
surface. Average the three readings. Record average gap (7) value.
Add 0.003 in. (0.08 mm) to average gap (7). This is the final shim pack (5) thickness for
e.
assembly.
f.
Remove six screws (4), washers (3), and cap (2) from housing (1).
9-52