TM 9-2320-260-34-1
8-6. TRANSMISSION MAINTENANCE (Contd)
NOTE
Perform step 12 forM816 vehicles. Perform step 13 for all
vehicles except M816.
For disassembly of shifter housing, proceed to para. 8-7,
subtask b.
12.
Remove ten screw-assembled lockwashers (2) from shifter housing (1). Discard screw-assembled
lockwashers (2).
13.
Remove twelve screw-assembled lockwashers (2) from shifter housing (1). Discard screw-assembled
lockwashers (2).
14.
Remove shifter housing (1) and gasket (3) from transmission (4). Discard gasket (3).
15.
Remove six screw-assembled lockwashers (7), cover (6), and gasket (5) from transmission (4).
Discard screw-assembled lockwashers (7) and gasket (5).
NOTE
Perform step 16 for transmissions equipped with transmission
power takeoff (PTO).
16.
Remove six nuts (19), lockwashers (18), PTO (20), and gasket ( 16) from studs (17). Discard
lockwashers (18) and gasket ( 16).
17.
Remove six nuts (11) and lockwashers (12) from studs (15). Discard lockwashers (12).
NOTE
Tighten puller screws evenly until input shaft cover is free from
transmission.
18.
Using two puller screws, remove input shaft. cover ( 13), seal (10), and gasket (14) from trans-
mission (4). Discard seal (10) and gasket (14).
19.
Remove two puller screws from input shaft cover (13).
NOTE
When removing input shaft, fourteen roller bearings may fall into
bottom of transmission case. Roller bearings must be retained for
assembly.
20.
Remove input shaft (9) and fourteen roller bearings (8) from transmission (4).
8-16
