TM 9-2320-240-34-1
3-42. FLYWHEEL AND CLUTCH REMOVAL
THIS TASK COVERS:
Removal
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-34P-1
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit
(Appendix B, Item 1)
GENERAL SAFETY INSTRUCTIONS
Two dowel pins (Appendix E, Figure E-1)
Flywheel is heavy. Use care when removing
flywheel.
1.
Remove twelve screws (8), lockwashers (9), pressure plate (1), and clutch disk (2) from flywheel (5).
2.
Remove six screws (6) and washers (7) from flywheel (5).
3. Install two dowel pins (10) on crankshaft (3) to support flywheel (5) during removal.
WARNING
Flywheel is heavy. Use care when removing flywheel. Failure to do
so may result in injury to personnel.
NOTE
Assistant will help with step 4.
4.
Install two screws (11) in flywheel puller holes (4) and tighten screws (11) alternately to push
flywheel (5) from crankshaft (3). Lift flywheel (5) from dowel pins (10).
5. Remove two dowel pins ( 10) from crankshaft (3).
6. Remove two screws ( 11) from flywheel puller holes (4).