TM 9-2320-260-34-1
3-24. ENGINE AND TRANSMISSION REPLACEMENT (Contd)
FOLLOW-ON TASKS:
Install transmission-to-transfer case propeller shaft (TM 9-2320-260-20).
Install transmission PTO to hydraulic pump driveshaft (if removed)
(TM 9-2320-260-20).
Install cab tunnel, rear tunnel, and toeboard (TM 9-2320-260-20).
Install gearshift lever (TM 9-2320-260-20).
Install surge tank (TM 9-2320-260-20).
Install engine oil dipstick and tube (TM 9-2320-260-20).
Install exhaust muffler (TM 9-2320-260-20).
Install right and left side panels (TM 9-2320-260-20).
Install air cleaner (TM 9-2320-260-20).
Install brush guard and stone guard (TM 9-2320-260-20).
Install lever wind (TM 9-2320-260-20).
Install hood (TM 9-2320-260-20).
Install fuel burning personnel heater (if removed) (TM 9-2320-260-20).
Install personnel hot water heater (if removed) (TM 9-2320-260-20).
Fill coolant system (TM 9-2320-260-20).
Fill transmission oil (LO 9-2320-260- 12).
Fill engine oil (LO 9-2320-260-12).
Close air reservoir draincocks (TM 9-2320-260-20).
Connect battery ground cables (TM 9-2320-260-20).
Adjust accelerator linkage (TM 9-2320-260-20).
Adjust clutch linkage (TM 9-2320-260-20).
CAUTION
Never start a new or repaired engine without performing run-in
Start engine (TM 9-2320-260-10), allow air pressure to build up to normal
operating range, and check for leaks. Road test vehicle.
3-96