TM 9-2320-260-20
THIS TASK COVERS:
a. Driver's Seatbelt Removal
c. Companion Seatbelt Removal
b. Driver's Seatbelt Installation
d. Companion Seatbelt Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Six locknuts
Parking brake set (TM 9-2320-260-10).
I
a. Driver's Seatbelt Removal
NOTE
Perform step 1 for driver's seat with long retaining rod.
1. Remove screw (41), washer (40), retractor (42), and tether (39) from retaining rod (12).
2. Remove screw (13), two washers (14), retractor (15), tether (18), and spacer (19) from retaining
rod (12).
3. Remove locknut (25), screw (16), two washers (17), and tether (18) from cab channel member (11).
Discard locknut (25).
4. Remove screw (23), two washers (22), anchor (21), and tether (20) from retaining rod (12).
5. Remove locknut (7), screw (24), two washers (8), tether (20), and spacer (9) from cab channel
member (10). Discard locknut (7).
b. Driver's Seatbelt Installation
1. Install spacer (9) in cab channel member (10).
2. Install tether (20) on cab channel member (10) with two washers (8), screw (24), and new
locknut (7). Tighten locknut (7) 20-25 lb-ft (27-34 N.m).
3. Install tether (20) and anchor (21) on retaining rod (12) with two washers (22) and screw (23),
Tighten screw (23) 40-45 lb-ft (54-61 N.m).
4. Install tether (18) on cab channel member (11) with two washers (17), screw (16), and new
locknut (25). Tighten locknut (25) 20-25 lb-ft (27-34 N.m).
5. Install spacer (19), tether (18), and retractor (15) on retaining rod (12) with two washers (14)
and screw (13). Tighten screw (13) 40-45 lb-ft (54-61 N.m).
NOTE
Perform step 6 for driver's seat with long retaining rod.
6. Install tether (39) and retractor (42) on retaining rod (12) with washer (40) and screw (41). Tighten
screw (41) 40-45 lb-ft (54-61 N.m).
1. Remove locknut (4), screw (28), three washers (3), and anchor (27) from bracket (26). Discard
locknut (4).
2. Remove locknut (30), screw (6), two washers (5), bracket (26), and spacer (29) from cab channel
member (2). Discard locknut (30).
3. Remove locknut (31), screw (34), three washers (32), and retractor (33) from bracket (37). Discard
locknut (31).
14-86
