TM 9-2320-260-20
THIS TASK COVERS:
a. Front Side Marker Lights Removal
c. Rear Side Marker Lights Removal
d. Rear Side Marker Lights Installation
b. Front Side Marker Lights Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Seven locknuts
Fourteen lockwashers
Parking brake set (TM 9-2320-260-10).
Four clips
Battery ground cable disconnected (para. 4-48).
Two gaskets
I
a. Front Side Marker Lights Removal
1. Remove four locknuts (16), screws (14), and cover (20) from hood (11) and fender (15). Discard
locknuts (16).
2. Disconnect lead (19) from wire (21).
3. Remove grommet (23) from lead (19), leads (22), and fender (15).
4. Remove two screws (9) and lens frame (8) from base (4).
5. Remove two clips (7) and lens (10) from lens frame (8). Discard clips (7).
6. Remove lamp (6) from base (4).
7. Remove four nuts (12), lockwashers (13), screws (5), base (4), and gasket (3) from bracket (2).
Discard lockwashers (13) and gasket (3).
8. Remove locknut (18), screw (1), two lockwashers (17), and bracket (2) from fender (15) and hood (11).
Discard locknut (18) and lockwashers (17).
b. Front Side Marker Lights Installation
1.
Install bracket (2) on fender (15) and hood (11) with two new lockwashers (17), screw (1), and new
locknut (18).
2.
Install new gasket (3) and base (4) on bracket (2) with four screws (5), new lockwashers (13),
and nuts (12).
Install lamp (6) on base (4).
3.
4.
Install lens (10) in lens frame (8) with two new clips (7).
Install lens frame (8) on base (4) with two screws (9).
5.
Insert lead (19) through hole in fender (15) and connect to wire (21).
6.
Place grommet (23) around lead (19) and leads (22), and install on fender (15).
7.
Install cover (20) on fender (15) and hood (11) with four screws (14) and new locknuts (16).
8.
14-74
