TM 9-2320-260-20
Section V. MlNI LIGHTING KITS MAINTENANCE
I
PAGE
PARA.
TITLE
NO.
NO.
Intermediate Turn Signal Light Replacement
Front and Rear Side Marker Lights Replacement
I
THIS TASK COVERS:
a. Removal
b.Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Two O-rings
Two screw-assembled lockwashers
Parking brake set (TM 9-2320-260-10).
Four locknuts
Battery ground cable disconnected (para. 4-48).
Seal
Lockwasher
a. Removal
1. Remove two lenses (2), O-rings (3), and lamp (1) from lamp housing (4). Discard O-rings (3).
2. Remove four locknuts (11), screws (8), and cover (13) from fender (10) and hood (9). Discard
locknuts (11).
3. Disconnect lead (15) from wire (14).
4. Remove grommet (7) from lead (15), leads (12), and fender (10).
5. Remove nut (17), lockwasher (18), lamp housing (4), and seal (5) from brushguard (6). Discard
lockwasher (18) and seal (5).
6. Remove two screw-assembled lockwashers (16) and brushguard (6) from hood (9). Discard screw-
assembled lockwashers (16).
I
b. Installation
NOTE
Ensure red lens on intermediate turn signal light is installed
facing rear of vehicle.
1. Install brushguard (6) on hood (9) with two new screw-assembled lockwashers (16).
2. Install new seal (5) and lamp housing (4) on brushguard (6) with new lockwasher (18) and nut (17).
3. Insert lead (15) through hole in fender (10) and connect to wire (14).
4. Place grommet (7) around lead (15) and leads (12), and install on fender (10).
14-72