TM 9-2320-260-20
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
All
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Five locknuts
Parking brake set (TM 9-2320-260-10).
Two cotter pins
GENERAL SAFETY INSTRUCTIONS
Do not perform this task when exhaust system is hot.
WARNING
Do not touch hot exhaust system components with bare hands.
Injury to personnel may result.
1. Remove two cotter pins (7) and exhaust tube (8) from heater (11) and oil pan shroud (4). Discard
cotter pins (7).
2. Remove locknut (2), screw (1), clamp (10), and exhaust tube (8) from crossmember (9). Discard
locknut (2).
3. Remove four locknuts (6), washers (5), and oil pan shroud (4) from engine oil pan (3). Discard
locknuts (6).
1. Install oil pan shroud (4) on engine oil pan (3) with four washers (5) and new locknuts (6).
2. Install exhaust tube (8) on heater (11) and oil pan shroud (4) with two new cotter pins (7).
3. Install exhaust tube (8) on crossmember (9) with clamp (10), screw (1), and new locknut (2).
14-38
