TM 9-2320-260-20
Section III. POWER TAKEOFF MAINTENANCE
PAGE
PARA.
TITLE
NO.
NO.
Transmission PTO Linkage Maintenance
Transfer PTO Control Linkage Maintenance (M815, M819 W/W)
Transmission PTO Control Linkage Maintenance (M820A2 WO/W)
THIS TASK COVERS:
a. Removal
d. Assembly
e. Installation
b. Disassembly
c . Cleaning and Inspection
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE
MODELS
All w/w
Parking brake set (TM 9-2320-260-10).
PTO lever in neutral position (TM 9-2320-260-10).
MATERIALS/PARTS
q Cab tunnel removed (para. 11-30).
Three cotter pins
GENERAL SAFETY INSTRUCTIONS
Ten locknuts
Lockwasher
q Keep fire extinguisher nearby when using
drycleaning solvent.
Two woodruff keys
Drycleaning solvent (Appendix C, Item 29)
q Compressed air source will not exceed 30 psi
(207 kPa).
Rags (Appendix C, Item 22)
q Eyeshields must be worn when cleaning with
REFERENCES (TM)
compressed air.
TM 9-2320-260-10
TM 9-2320-260-20P
1.
Remove two cotter pins (8), clevis pins (10), and link rod (9) from control lever (6) and lever (11).
Discard cotter pins (8).
2.
Remove two locknuts (2), screws (37), bracket (l), control lever (6), and spacer (7) from
crossmember (36), and shaft (34). Discard locknuts (2).
3.
Remove cotter pin (25), clevis pin (23), and connecting rod (24) from lever (19). Discard cotter
pin (25).
4.
Remove four locknuts (27), screws (14), two brackets (15), and shaft (17) from crossmember (35).
Discard locknuts (27).
5.
Remove screw (30) and lockwasher (31) from power takeoff (33) and power takeoff lever (28).
Discard lockwasher (31).
6.
Remove locknut (29), screw (32), and power takeoff lever (28) from power takeoff (33). Discard
locknut (29).
13-134
