CAB TUNNELS REPLACEMENT

TM 9-2320-260-20

11-30. CAB TUNNELS REPLACEMENT

THIS TASK COVERS:

a. Tunnel Removal

d. Toeboard Installation

e. Rear Tunnel Installation

b. Rear Tunnel Removal

c. Toeboard Removal

f. Tunnel Installation

INITIAL SETUP

REFERENCES (TM]

APPLICABLE MODELS

TM 9-2320-260-10

All

TM 9-2320-260-20P

MATERIAIS/PARTS

EQUIPMENT CONDITION

Thirty-two screw-assembled lockwashers

Parking brake set (TM 9-2320-260-10).

Two locknuts

Companion seat removed (para. 11-31).

1. Remove thirteen screw-assembled lockwashers (4) and tunnel (3) from rear tunnel (8), toeboard (1),

and cab floor (10). Discard screw-assembled lockwashers (4).

NOTE

Perform step 2 if vehicle is equipped with lever lock.

2. Remove two locknuts (9), screws (6), and lever lock (5) from tunnel (8). Discard locknuts (9).

b. Rear Tunnel Removal

Remove ten screw-assembled lockwashers (7) and rear tunnel (8) from cab floor ( 10). Discard screw-

assembled lockwashers (7).

Remove nine screw-assembled lockwashers (2) and toeboard (1) from cab floor (10). Discard screw-

assembled lockwashers (2).

Install toeboard (1) on cab floor (10) with nine new screw-assembled lockwashers (2).

Install rear tunnel (8) on cab floor (10) with ten new screw-assembled lockwashers (7).

NOTE

Perform step 1 if vehicle is equipped with lever lock.

1. Install lever lock (5) on tunnel (8) with two screws (6) and new locknuts (9).

2. Install tunnel (3) on rear tunnel (8), toeboard (1), and cab floor ( 10) with thirteen new screw-

assembled lockwashers (4).

11-56