TM 9-2320-260-20
13-59. POWER
DIVIDER YOKE AND
SEAL REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
M816
q Parking brake set (TM 9-2320-260-10).
q Power divider-to-rear winch drive propeller shaft
MATERIALS/PARTS
Five lockwashers
q Power divider-to-transfer propeller shaft removed
Gasket
Seal
q Power divider-to-hydraulic pump propeller shaft
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
NOTE
The left and right yokes are replaced basically the same. This
procedure covers the left side yoke and seal.
1. Remove screw (1), lockwasher (2), washer (3), gasket (4), and yoke (5) from housing (6). Discard
lockwasher (2). Discard gasket (4).
2. Remove four screws (11), lockwashers (10), and retaining plate (9) from housing (6). Discard
lockwashers (10).
3. Remove gasket (7) and seal (8) from retaining plate (9). Discard gasket (7) and seal (8).
1. Install new seal (8) and new gasket (7) on retaining plate (9).
2. Install retaining plate (9) on housing (6) with four new lockwashers (10) and screws (11).
3. Install yoke (5) on housing (6) with new gasket (4), washer (3), new lockwasher (2), and screw (1).
13-132