TM 9-2320-260-20
I
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
M816
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Four lockwashers
q Parking brake set (TM 9-2320-260-10).
q Drivechain and sprocket removed (para. 13-17).
1. Remove two nuts (7), screws (1), four lockwashers (2), and plate (4) from roller bracket (3). Discard
lockwashers (2).
2. Remove shaft (5) and roller (6) from roller bracket (3).
3. Remove rear winch propeller shaft (8) from yoke (10) and center bearing (9).
4. Guide propeller shaft (8) through rear crossmember 11).
1. Guide propeller shaft (8) through rear crossmember (11).
2. Install rear winch propeller shaft (8) in center bearing (9) and yoke (10).
3. Install roller (6) and shaft (5) on roller bracket (3) with plate (4), four new lockwashers (2), two
screws (1), and nuts (7). Tighten nuts (7) 70-98 lb-ft (95-133 Nm).
13-128
