TM 9-2320-260-20
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-260-10).
All W/W
Winch cable, chain, and hook removed
MATERIALS/PARTS
Six locknuts
Front winch propeller shaft removed (para. 13-9).
Fourteen lockwashers
GENERAL SAFETY INSTRUCTIONS
REFERENCES (TM)
All personnel must stand clear during lifting
LO 9-2320-260-12
operations.
TM 9-2320-260-10
TM 9-2320-260-20P
1. Install chains around winch (2) and on lifting device.
2. Remove six locknuts (3), screws (7), and washers (8) from two support brackets (9) and mounting
brackets (4). Discard locknuts (3).
3. Remove six screws (1), lockwashers (11), and washers (10) from two mounting brackets (4) and rail
reinforcements (12). Discard lockwashers (11).
WARNING
All personnel must stand clear during lifting operations. A swing-
ing or shifting load may cause injury to personnel.
NOTE
Assistant will help with step 4.
4. Raise winch (2) and two mounting brackets (4) from vehicle, and lower winch (2) onto supports.
5. Remove chains from winch (2) and lifting device.
6. Remove eight screws (6), lockwashers (5), and two mounting brackets (4) from winch (2). Discard
lockwashers (5).
13-18
