TM 9-2320-260-20
THIS TASK COVERS:
c. Installation
a. Removal
b. Cleaning and Inspection
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
All W/W
Parking brake set (TM 9-2320-260-10).
Winch prepared for use (TM 9-2320-260-10).
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Lubricating oil (Appendix C, Item 19)
Rags (Appendix C, Item 22)
Wear hand protection when handling winch cable.
Eye protection is required when using a wire
REFERENCES (TM)
brush for cleaning.
LO 9-2320-260-12
TM 9-2320-260-10
TM 9-2320-260-20P
WARNING
Wear hand protection when handling winch cable. Broken wires
may cause injury to personnel.
1. Unwind cable (4) from winch (2) (TM 9-2320-260-10).
2. Remove setscrew (1) and cable (4) from winch drum (3).
NOTE
Two types of cable connectors maybe found on M809 series
winches.
3. Hollow clevis type:
a. Remove nut (7), screw (5), and chain (8) from clevis yoke (6).
b. Remove cap (10), cable (4), and plug (9) from clevis yoke (6).
c. Remove plug (9) and cap (10) from cable (4).
4. Half clamp type:
a. Remove clamp nut (13), loop (12), and half clamps (14) and (15) from cable (4).
b. Remove hook (11) from loop (12).
13-10
